Publicité
Les langues disponibles
Les langues disponibles
Compass Rallye Package
It is necessary to trim bumper
fascia. Obtain vehicle owners
approval for cutting plastic fascia
before installing hitch!
Frame
Ground
Figure 4
** X (from ground to bottom of frame) must be
measured to double check placement of cut. X-5
inches is the distance measured from the ground
to the top of the fascia cut.
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
2011 Cequent Performance Products
z
Installation Instructions
Jeep Compass*,
Jeep Patriot*,
Note 2.
See diagram.
Rear view of Rallye showing
section of fascia to trim out
Jeep Compass Rallye Model
Rallye Package
inc.
optional tow hook
inc.
*2011 and Later Jeep Patriot and Compass
models require fascia trimming for hitch
installation. Obtain vehicle owner approval
before cutting.
COMPASS
Shown with hitch in place.
COMPASS
Cut up to cross hatch pattern in fascia
Figure 2
Center Line of
Vehicle
Fascia Tabs
Ref 2"(51mm) **
3" (76mm)
6-5/8" (168mm)
Figure 3
Fascia Trimming Diagram for
2011 & Later Jeep Patriot and Compass Models
Sheet 2 of 6
Part Numbers:
Fascia Cut Line
Fascia Tabs
1-1/2" (38mm)
51085N
07/14/11
Form: F205 Rev A 5-6-05
51085
Rev. D
Publicité
