Télécharger Imprimer la page

Kimpex 373955 Instructions D'assemblage page 8

Publicité

Les langues disponibles

Les langues disponibles

MOUNT PLATE FOR "CLICK'N GO 2" SNOWPLOW FRAME
Can-Am Outlander
2012 MODELS AND NEWER
(For 2011 models and later, go to page 3)
1) U se the template provided at the end of this instruction
(page 5) and follow the steps listed on.
2) P osition the template under the vehicle (left side) and
aligned the holes No.1 with the holes of the protective
plate.
Front
3) M ark the center of the hole No.2 on the protective plate
using a marker or a punch. Drill the mounting hole with a
1/2" dia drill bit.
Front
4) I nsert a
M10-1.5 X 40 mm
support plate f. Slide the assembly inside the left footpegs
support by passing through the mounting hole drilled in
step 3. Repeat this step for the opposite side as illustrated.
KIMPEX INC. / 5355, rue St-Roch / Drummondville (Québec) Canada / J2B 6V4
7815019
A-7815019
MOUNTING INSTRUCTIONS
BOTTOM VIEW
1/2" dia
BOTTOM VIEW
carriage bolt h into the hole of a
KIMPEX USA / 100 Walnut Street / Champlain, New York / 12919
8
6
Front
5) A ssemble the "A" bended support b and a support (2012
model) d using
(3) M8-1.25 X 25 mm
self-locking flange nuts l. Repeat with the "B"
M8-1.25
bended support c.
2
12
6) P osition the left and right assemblies under the vehicle
and fasten using the carriage bolts h and the support
plates f installed in step 4. Held in place using the
self-locking flange nuts k (finger tighten at this
M10-1.5
time).
7) F asten the other ends of the assemblies using the
clamping plate e, the
and the
self-locking flange nuts l (finger
(2) M8-1.25
tighten at this time ).
Printed in China
373955
#
Kimpex
8
BOTTOM VIEW
6
carriage bolts i and
9
3
9
4
4
12
carriage bolts g,
(2) M8-1.25 X 65 mm
(3)
(2)
2

Publicité

loading

Produits Connexes pour Kimpex 373955