Technical Specification - Hällde RG-100 Mode D'emploi

Masquer les pouces Voir aussi pour RG-100:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 18
ADVICE ON CARE:
• Clean the machine immediately after use.
• Dry the machine immediately after cleaning
to avoid oxidation and discoloration of the
surface.
INFORMATION: If the machine is left
damp for longer periods stains will appear.
These stains are harmless but the original
surface will lose its lustre. Vegetables and fruit
contain acids. Depending on which products
are processed this will have an effect on the
metal after varying periods of time. It is there-
fore important to clean the machine immedia-
tely after processing salty and acidic products.
TROUBLE SHOOTING
To eliminate the risk of damage to the motor,
the RG-100 is fitted with thermal motor protec-
tion that automatically switches off the machine
if the temperature of the motor should become
too high. The thermal motor protection has
automatic reset, which means that the machine
can be started again when the motor has
cooled down, which usually takes between 10
and 30 minutes.
FAULT: The machine cannot be started,
or stops while it is running and cannot be
restarted.
REMEDY: Check that the plug is securely fitted
into the power supply socket. Check that the
feed cylinder is locked in the correct position.
Move down the pusher plate into the feed
cylinder. Check that the fuses in the fuse box for
the premises have not blown and that they have
the correct rating. Wait for a few minutes and
try to restart the machine. If the machine still
fails to run, call in a qualified service mechanic
to remedy the fault.
FAULT: Low capacity or poor cutting results.
REMEDY: Make sure that you are using the
correct cutting tool or combination of cutting
tools. Check that the knives and grater/
shredder plates are in good condition and
are sharp. Press the food down loosely with
less force.
FAULT: The cutting tool cannot be removed.
REMEDY: Use a thick leather glove or other
glove that the knives of the cutting tool cannot
cut through, and turn the cutting tool clockwise
to release it.

TECHNICAL SPECIFICATION

HALLDE RG - 100
MACHINE: Motor: 0.25 kW, 230 V, single-
phase, 50 Hz, with thermal motor protection.
Transmission: gears. Safety system: Two
safety switches. Degree of protection: IP44.
Power supply socket: Earthed, single-phase,
10 A. Fuse in fuse box for the premises: 10 A,
delayed. Sound level LpA (EN31201): 70 dBA.
TOOLS: Diameter: 185 mm. Speed: 350 rpm.
NET WEIGHTS: Machine: 16 kg. Cutting tools:
About 0.5 kg on average.
4
NORMS/STANDARDS: NSF STANDARD 8,
see declaration of conformity.
HALLDE • User Instructions

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Rg-200

Table des Matières