Publicité
Les langues disponibles
Les langues disponibles
Fitting kit
- 2 BHc 6x15 screws (big head)
- 2 BHc 6x20 screws (small head)
- 2 Ø6 rubber washers
Assembly
- Cut the small protective mudguard of the suspension.
- Remove the chainguard
- Dismantle the 2 original fixation of the brake hose.
- Place and fit the rear hugger thanks to the 2 BHc 6x15 screws and rubber washers (between the
head of the screw and the rear hugger not to damage the painting) on the chainguard side.
- Replace both original screws of the brake hose fixation by the 2 provided BHc 6x20 screws.
- Centre the rear hugger to the tire and moderately tighten the 4 screws.
* Painted and varnished parts are not guaranteed against high pressure steam washes or aggressive cleaning products which can damage them and unstuck the varnish. We advise moreover, according to the technical data of
our painting suppliers, to wait one month to obtain a complete polymerization of varnish.
* Accessories gone up on the motorbike will not be any more considered as new and will be neither retaken nor exchanged.
* Ermax accessories are foreseen for original equipments. They will not be guaranteed if they are used in others conditions.
* Due to vehicles made tolerances, beyond our control, some Ermax products might need adjustings to fit.
* A few tyres, as Dunlop D207 or Michelin Pilot Power, not being for the given dimensions, are not compatible with undertray and rear hugger made for original tyres in standard dimensions.
* Harden the rear shock absorber while drivings with load or on dented roads.
* Aluminium screws are garanted until 6 Nm by our suppliers. Care to excessive clampings which may damage or break screws.
Ermax rear hugger and undertray are compatible.
« CAUTION »
FITTING INSTRUCTIONS
« REAR HUGGER »
650 BANDIT 2009 → ∞
Original tyre : Bridgestone Battlax BT020 160x60 ZR17
Publicité
