Imetec M5701 Mode D'emploi page 8

1. Power supply cord
2. O/I button
3. Handle
For the appliance features, refer to the external packaging.
To be used only with the accessories supplied.
ATTENTION! Never use the appliance if the blades are damaged or the blade
locking device does not work properly.
Warning: Never use the appliance on wet hair.
Make sure the hair is dry and clean, with no trace of hairspray, hair mousse or gel. Then brush
the hair in the direction of growth to remove all knots.
ATTENTION ! Switch the appliance off before changing any accessories.
Using SPACER combs (9 A, B, C ,D, E, F)
Spacer comb
None
A
B
C
Follow these instructions to insert a spacer comb:
• Choose the desired spacer comb (4), apply it on the product.
• Ensure that the spacer comb is inserted properly.
• Switch the appliance on by pressing the O/I button (2). Always switch the appliance off
when not in use.
• The appliance can also be used without the spacer comb (4) to trim hair very close to
the skin (1 mm) or shape around the nape of the neck and the area around the ears..
USEFUL RECOMMENDATIONS
• Start with the highest setting of the spacer comb and gradually decrease it until you have
the desired hair length.
• For optimal results, use the device with the blades facing the opposite direction of hair
growth.
• Move the appliance in different directions (upwards, downwards and sideways) because
not all hair grows in the same direction.
• If a lot of hair has accumulated in the spacer comb, remove the comb from the appliance
and blow and/or shake out the accumulated hair.
• Take note of the hair length settings used to create a certain style as a reminder for future
sessions.
ATTENTION! Always turn off the device before cleaning and replacing the
accessories! Make sure that any components that have been cleaned with a
damp cloth are completely dry before using them again or putting them away!
Clean the appliance immediately after each use and when there is hair or dirt trapped in the
blade locking device.
• Do not clean the appliance with abrasive powders or liquids, such as alcohol or petrol.
• Do not place the appliance in water or any other form of liquid to prevent damaging it.
BLADE LOCKING DEVICE
• Switch the appliance off and disconnect the adaptor plug (1).
• If inserted, remove the spacer comb (4) from its place.
The product is packaged in recyclable materials.
Dispose of these in an appropriate environmentally friendly manner.
Pursuant to European Standard 2002/96/EC, the appliance must be disposed of at the
end of its life span in a compliant manner. This regards recycling useful substances in the
appliance, which reduces the environmental impact. For further information, contact the
local disposal body or the appliance dealer.
To request repairs or purchase spare parts, please contact IMETEC's authorised customer
4. Spacer comb:
4A. 3 mm
4B. 6 mm
4C. 9 mm
OPERATING INSTRUCTIONS
Length obtained
1 mm
4 mm
7 mm
10 mm
MAINTENANCE
DISPOSAL
ASSISTANCE AND WARRANTY
5. Technical data
Spacer comb
D
E
F
6
4D. 13 mm
4E. 18 mm
4F. 21 mm
Length obtained
14 mm
19 mm
22 mm