Replacing The Gun Solenoid - NAMCO POINT BLANK 2 Manuel De L'opérateur

5-6

Replacing the Gun Solenoid

1. Remove the Gun Assembly.
2. Remove the Gun Slides.
3. Remove the gun covers.
4. Disconnect the solenoid connector.
5. Remove 1off cap bolt (M3x10) and remove the solenoid bracket.
6. Remove 1off cup screw (M) (M3x8) and detach the ground wire.
7. Remove 2off cup screws (M) (M4x6) and remove the slide guide.
8. Slacken the nut (16mm dia.) and
remove the solenoid complete with
plunger.
9. Pull the plunger out from the
solenoid taking care not to lose the
spring.
10. Reassemble in reverse order.
Note: When reassembling, match
the D-type hole of the solenoid bracket to the D shape of the solenoid and ensure
that the 'E' rings and spacers are in their correct positions.
(see section 5-3 page 53)
(see section 5-4 page 54)
(see section 5-5 page 55)
Page 56