Publicité
Step 7
Separate the EXTENSION SLIDES (35MC) from the EXTENSION RAILS (35MA) as shown in the enlarged diagram below.
å
Be prepared, the parts are greasy.
Fasten the EXTENSION RAILS (35MA) to the ENDS (A and B) and UPRIGHTS (C and D). Use eight GOLD 5/16" FLAT
å
HEAD SCREWS (3S).
NOTE: For each EXTENSION RAIL, turn a SCREW into the hole shown in the enlarged diagram. Then, slide the inner cartridge of
å
the EXTENSION RAIL in to fi nd the other hole that lines up with the hole in the END or UPRIGHT. Turn a SCREW into this hole.
35MC
Push the black lever in and pull the SLIDE from the RAIL.
Open end
Open end
www.sauder.com/service
A
B
LEFT END ASSEMBLY
C
35MA
RIGHT END ASSEMBLY
Open end
D
424988
Open end
GOLD 5/16" FLAT HEAD SCREW
(8 used in this step)
3S
Page 11
Publicité
