Regalo 164 EW Manuel D'instructions page 4

Operating the Door Latch
STEP 1
Pull the spring lock away from the secure lift latch while
simultaneously lifting the lock lever upwards. This will release
the locking latch from the gate frame and allow the door to
push or pull open. To lock the door shut, close the door
completely, then push down on the lock lever to re-engage the
spring lock.
Positioning and Attaching Wall Cups
STEP 1
After you have mounted your gate, and you are
satisfied with its positioning, draw a circle on
the surface of your doorway or opening around
the perimeter of the (4) rubber feet.
Next, completely remove the gate from the
opening by loosening each of the (4) threaded
spindle rods to depressurize the gate.
SPRING LOCK
LOCK LEVER
STEP 2
With the gate fully removed, you can now use the
circles you marked during Step 1 as guides for
screwing in your (4) wall cups (D). Center each of
the wall cups within the guide circles and use the
provided self-tapping 25mm screws (E) to fasten
them in place via the hole through the center of
each wall cup.
STEP 2
BASE LOCK
At the bottom of the gate door, rotate the base lock to the horizontal
position to allow the door to swing open.
NOTE:
Place lock down on side occupied by the child.
STEP 3
Reinstall your gate in the doorway or opening
according to the instructions, using the newly
installed wall cups as anchoring points for
the (4) threaded spindle rods.