Electrical Connection; Inserting The Batteries; Connecting The Power Supply Adapter; Operation - Hama BC-100 Mode D'emploi

Electrical connection

The devices are provided by the included power supply adapter or alkaline
batteries/rechargeable batteries (not included).
GB

Inserting the batteries

u Push the battery cover in the direction indicated
u Insert four alkaline batteries/rechargeable batteries

Connecting the power supply adapter

First, plug the connection cable into the socket on the device.
u
Then plug the power supply adapter into a power outlet.
NOTE
► Use the enclosed power supply adapter only.
The rechargeable batteries in the parent unit automatically begin
to charge when the power supply adapter is attached. During the
charging process, the charge symbol fl ashes as shown in "LED
display" (see page 10).
NOTE
► The duration of the charging process depends on the type of
rechargeable battery being used and its storage capacity.
34
00092667bda.indd Abs3:34-Abs3:35 00092667bda.indd Abs3:34-Abs3:35
All manuals and user guides at all-guides.com
Baby-Control BC-100

Operation

Baby unit

u Place the transmitter in the room to be monitored.
u To switch the unit on, set the operation selection switch on the
right side of the device to "MIC LOW" or "MIC HI" for low/high
microphone sensitivity.
u Move the channel selection switch to "CH1" or "CH2" to defi ne
the channel to be used.
NOTE
► Make sure that the microphone on the front of the transmitter is
not covered.
► The transmitter is sensor-activated and only transmits when the
noise level is high enough.

Parent unit

u To switch the unit on, turn the combination ON/OFF switch
clockwise.
u Use the ON/OFF switch to adjust the volume.
Move the channel selection switch to the same position that you
u
selected for the baby unit.
u For practical purposes, you can use the clip to attach the parent
unit to your belt (or other convenient location)
Baby-Control BC-100
GB
35
27.10.2009 15:58:01 Uhr 27.10.2009 15:58:01 Uhr