Connections; Connecting The Playback Components - Kenwood KA-S10 Mode D'emploi

Connections

Connecting the playback components

CONNECTION PRECAUTIONS
Do not connect the power cord plug into the power
outlet until all other connections are complete.
Before unplugging a cord or cable from the unit, be
always sure to set the POWER switch to OFF and
unplug the power plug from the power outlet.
CAUTION
Simply setting the POWER switch to OFF does not
shut down the power supplied to the unit com-
pletely. To isolate this unit completely from the
power supply, it is necessary to unplug the power
cord from the power outlet.
To shut down the power supply to the unit immedi-
ately in case of an emergency, connect the power
plug to an easily accessible power outlet.
White
Audio cord
(provided
accessory)
÷ In case an associated system component is connected, also read the instruction manual of the component.
÷ Be sure to insert all connection cords securely. If their connections are imperfect, the sound may not be
produced or noise may interfere.
6
ENGLISH
Red
AUDIO OUT
(LINE OUT)
HDD audio player etc.
CAUTION
Be sure to adhere to the following, or proper ventila-
tion will be blocked causing damage or fire hazard.
÷ Do not place any objects impairing heat radiation
onto the top of the unit.
÷ Leave some space around the unit (from the largest
outside dimension including projection) equal to or
greater than, shown below.
Top panel : 50 cm Back panel : 10 cm
÷ Do not place the equipment onto a bed, a sofa, a
carpet, or similar. Sucked-in dust can cause fire.
Insert the power plug all the
way and securely into a power
outlet.
Select the input connectors according to the type of
the component connected to it.
The D.AUDIO input is provided with high input gain so
that it can accept the input from the headphones out-
put of a portable component such as a HDD (Hard Disc
Drive) audio player. If the line output from a desktop
component such as a CD player is connected to these
connectors, the audio is played at a larger volume than
when it is connected to the CD or AUX connectors. In
this case, however, the audio may be distorted if the
listening volume is set too high.
Power plug
To AC wall outlet
CD player etc.