Publicité
EN
HOW TO ATTACH THE DEVICE?
The OxiTurm light can be attached to the majority of urban helmets using the magnetic mount (supplied in the box),
and to any other support (sports helmets, bicycles, scooters) using the kit of additional fasteners available on our
website (not included).
Attaching the magnetic mount: before attaching the magnetic mount by removing the protective film from the
adhesive, make sure to clean the helmet's attachment surface with lukewarm water only. Do not use any solvents.
WARNING! Make sure that the magnetic mount is correctly positioned on the helmet as it cannot be removed, so
that the lighting is in the right (see figure 1 page 2).
FIRST USE.
Before first use, fully charge the battery using the cable provided and connected to a 5V USB charger (see figure 3 on
page 3). A flashing red light indicates that the light is charging. The flashing light will turn orange, if the light is at more
than 50% capacity. When the light turns off, the battery is fully charged. Elastic straps are provided for mounting the
OxiMote remote control on a handlebar (see figure 4 on page 3). Choose the most suitable length. You can use one or
two elastic bands, depending on the shape of the handlebars. The remote control works with a CR2032 battery already
in place. The battery can be changed by removing the 3 screws with a screwdriver (see figure 5 page 3).
FUNCTIONNING.
To turn on the OxiTurn light, press the ON/OFF button located in the centre of the front panel. To turn it off, press the
button for 2 seconds. To switch from one light mode to another, simply press the ON/OFF button. The power and
operating times for each mode are shown at the back of the packaging. After switching your light on or off, the charge
indicator turns green for a few seconds or red when the battery level is low.
The direction indicators are activated by the OxiMote remote control. When a turn signal is activated, an audible
reminder confirms that it is working, as well as an illuminated reminder on the OxiMote. To change the sound, press
the ON/OFF button for at least 6 seconds when the OxiTurn light is off. A sound signal indicates that the change has
been made. To deactivate the sound, repeat the operation a second time.
WARNING! The use of flashing lights may be regulated in some countries. Observe the applicable law.
PRECAUTIONS FOR USE.
WARNING! This product is a supplementary light, it cannot replace the vehicle lighting defined by the Highway Code.
Do not immerse the product in water and do not dismantle the light, as this will invalidate the warranty. Do not
dispose of the battery in fire (risk of explosion).
WARNING! This product and batteries it contains cannot be disposed of with household waste. They are subject to
selective sorting and must be deposited in an authorised collection area for recycling.
WARRANTY.
We apply the legal warranty periods on all our products. For more information on terms and conditions, please
contact your local dealer or visit our website at www.overade.com
Publicité
