Extending The Hitch; Using The Parking Brake Strap; Using The Harness System - CoPilot MODEL T Mode D'emploi

EXTENDING THE HITCH

Tip the trailer back on its frame so the underside
is fully visible. Remove the grenade pin and rotate
the hitch arm upward until fully extended. Reinsert
the grenade pin and lock the spring clip. Figure
For folding and storage, reverse the process and
be sure to insert the pin fully and lock it with the
spring clip.

USING THE PARKING BRAKE STRAP

The trailer is equipped with a strap parking brake
that is quick and easy to use while loading or when
the trailer is fully assembled and stored.
To use the strap, unclip it from the D-Ring and wrap
around the wheel at its closest point – hooking it
securely back onto the D-Ring. Figure
USING THE SAFETY HARNESS SYSTEM
There are two sets of shoulder harnesses positioned side by side on the seat back. The
two sets of shoulder harnesses are comprised of four separate shoulder straps (straps
A, B, C and D) and three separate crotch straps (straps 1,2 and 3). Figure
children passengers, use shoulder straps A and B with crotch strap 1 and shoulder
straps C and D with crotch strap 2. This will position the two children side by side.
When carrying only one child passenger, the child may sit in the center using straps
B, C and 3.
Disconnect the shoulder harness clips and the seat
belt buckle. Place the children side by side on the
seat. Place shoulder strap A over the first child's
right shoulder and shoulder strap B over the first
child's left shoulder. Place shoulder strap C over
the second child's right shoulder and shoulder
strap D over the second child's left shoulder.
Each child's height will determine the position of
his/her respective shoulder straps. The shoulder
strap height may be adjusted by routing the straps
8
| english
.
3A
3A
4A
.
4A
5A
. For two
5A
E
C D
A B
1
2
3