Conversion Kit Assembly; Detaching Wheels; Stowing The Frame & Seat - CoPilot MODEL T Mode D'emploi

CONVERSION KIT ASSEMBLY

The conversion kit consists of a rear handle and front
wheel assembly that attach to the trailer to convert it
for walking use.
The front wheel attaches to the trailer frame. Remove
pin, slide in front wheel, replace pin and secure
clamp.
The handle bar attaches to the rear side support
frame up- rights with clamps. Loosen the quick-
release knobs, slide the clamps through the portholes
provided in the fabric, around the frame and tighten
the nut while clamping down the quick-release lever.
Adjust as needed. Tug on the handle bar to make
certain that it is tight on the frame. Figure
Remove the conversion kit wheel and handle bar before towing the trailer. The wheel
can catch on the ground and the handle bar can hook onto things unexpectedly
while turning.

DETACHING WHEELS

9A
STOWING THE FRAME & SEAT
10A
10
| english
.
8B
9B
10B
8A
8B
9C
10C