Publicité
Les langues disponibles
Les langues disponibles
Liens rapides
Hitch Shown In Proper Position
Equipment Required:
Fastener Kit: 51153F
Wrenches: 14mm, 17mm
Drill Bits: None
Frame Rail
j
Qty. (6)
Hex Bolt M10 x 1.25x 30mm CL10.9
1.
Remove tow hooks from frame rails and return to vehicle owner.
2.
Remove plastic caps in forward attaching holes.
3.
Raise hitch into position and install fasteners as shown above.
Tighten all M10 x 1.25 CL10.9 fasteners with torque wrench to 42 Lb.-Ft. (57 N*M)
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to prevent
entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working beneath a
vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and
SAE J684.
z
2009, 2012 Cequent Performance Products
Installation Instructions
Lexus RX300
Toyota Highlander
Fascia
Existing Weldnut
k
Sheet 1 of 3
Do Not Exceed Lower of Towing Vehicle
Manufacturer's Rating or
Hitch type
Trailer WT (LB)
Weight Distributing
Weight Carrying
3500 (1589 Kg.)
Ball Mount
Wiring Access Location: SUV1, SUV2
Conical Toothed Washer 3/8"
Qty. (6)
51153N
Part Numbers:
51153
97153
Max Gross
Max Tongue
WT (LB)
Do Not Use With Spring Bars
350 (159 Kg.)
Fasteners Typical
Both Sides
2-1-12
Rev. B
Form: F205 Rev A 5-6-05
Publicité
Manuels Connexes pour Cequent Performance Products 51153
Sommaire des Matières pour Cequent Performance Products 51153
- Page 1 Do not cut access or attachment holes with a torch. This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5 and SAE J684. 2009, 2012 Cequent Performance Products Sheet 1 of 3 51153N 2-1-12 Rev.
- Page 2 Ce produit est conforme aux normes V-5 et SAE J684 de la V.E.S.C. (État de New York) concernant les spécifications en matière de sécurité des systèmes d’attelage. 2009, 2012 Cequent Performance Products Feuille 2 de 3...
- Page 3 No corte los orificios de acceso o accesorios con soplete. Este producto cumple con las especificaciones y requisitos de seguridad para conectar dispositivos y sistemas de remolque del estado de Nueva York, V.E.S.C. Regulación V-5 y SAE J684. 2009, 2012 Cequent Performance Products Hoja 3 de 3...