SantaFe QM2RCAN Manuel Du Propriétaire page 6

1. Carefully unpack the Quesadilla Maker.
2. Wipe all surfaces with a slightly damp, soft cloth. NEVER immerse unit
in water.
3. Before preheating the Quesadilla Maker, the Cooking Plates
may be brushed with a small amount of vegetable oil. This helps to
protect the non-stick surface. You may wish to repeat this procedure
periodically.
4. Set the appliance on a clean, dry and flat surface, where it can be
easily plugged into a 120V AC electrical outlet.
5. To preheat the Quesadilla Maker: close the Lid and plug
cord into electrical outlet. Both the Red Power/ON Indicator Light and
Green Ready (Cook) Light will illuminate, and the unit will immediately
begin heating. NEVER OPERATE THE APPLIANCE UNATTENDED.
Allow the unit to preheat for approximately 5 minutes. The Green
Ready (Cook) Light will turn off when the unit has reached cooking
temperature.
6. Gently raise the Quesadilla Maker Lid using a pot
holder/oven mitt. Always grasp Lid with a pot holder/oven mitt when
raising and lowering Lid. As with any new appliance, you may notice
smoke and a slight odor when unit is used for the first time while
residues burn off the Cooking Plates and heating element. Allow the
Quesadilla Maker to heat until smoke and odor dissipate.
NOTE: Some odor may still be detected during initial use; this is
normal and should disappear after one or two uses.
1. Check to ensure that the Cooking Plates are clean and free from dust
and food particles. If necessary, wipe with a damp cloth.
2. When using the Quesadilla Maker for the first time, lightly
brush the Cooking Plates with vegetable oil.
3. Close the Lid.
Before Using Your
quesadilla Maker
For The First Time
How To Use Your
quesadilla Maker
6