RED CASTLE RECARO Mode D'emploi page 14

RED CASTLE / RECARO car seat Gr. 0 +
1. How to install the attach brackets
- Detach the seat from your stroller and remove the hood* (1).
- Set the Attach brackets in place as shown (2): position them one on either
side of the chassis, from the inside to the outside (3). The press stud should
slot into the hole (4).
- Secure the Attach brackets in place, "click" heard (5).
(*) (cf. stroller Instruction manual).
WARNING
: Check that the Attach Brackets are securely in place before
installing the car seat.
IMPORTANT! NEVER LIFT UP the stroller by the car seat, but ONLY BY THE
CHASSIS.
2. How to install the car seat
- Position the car seat as shown (6) and push firmly downwards to secure
it onto the stroller, (click heard).
You can then put the handle of the car seat in the best suitable position.
To remove the car seat from the stroller:
To make it easier to remove, put the handle of the car seat in the raised
position when removing it from the chassis**.
- Release one side first by pressing on the knob on the side of the car seat
then lift it up a little to free it (7).
- Repeat for the other side. (The car seat is no longer attached) (7).
(*) cf. Instructions for use for the WHIZZ or for the SHOP'N JOGG II.
(**) Handle positions (cf. RED CASTLE / RECARO car seat Instructions for use).
Attach brackets for the
1
GB
2
13