Dostmann Log100 Mode D'emploi page 8

DE_Log100_Cryo_Anleitung
LOG100/110/CRYO
– Data logger
1.3 Standard settings / Factory settings
• Note the following default settings of the data logger before first use. By
using the DE-LOG-Graph software, the setting parameter can easily be
changed:
1. Description: blank (max. 16 characters)
2. LCD-Snooze mode:
3. LCD-Snooze after Sec.: 10
4. Mode-button active:
5. Alarm settings for temperature:
Log100/110: -30,0°C 70,0°C -40,0°C 150,0°C
Log100CRYO: -10,0°C 70,0°C -200,0°C 350,0°C
Alarm settings humidity:
6. Alarm delay: □
7. Alarm cumulation: off
8. Alarm reset:
9. Alarm-LED-interval 3 seconds
10. Alarm-LED-blink duration 1 second
11. Alarm-Buzzer-interval 30 seconds
12. Alarm-Buzzer-duration 1 second
13. Temperature unit: °C
14. Start-button active:
15. Start by Reed-contact: □ (by request only)
16. Waiting for manual start:
17. Single use only:
18. Measuring interval: 15 Minutes
19. Stop-button active:
20. Stop by Reed-contact: □ (by request only)
21. Cycle memory: (if the memory is full the oldest measurement will be
overwritten)
= Default
14
11.10.2013 15:35 Uhr Seite 8
0,0% 100,0% (Log110 only)
LOG100/110/CRYO
– Data logger
1.4. Marking (Log100 only)
• CE-conformity, EN 12830, EN 13485, Suitability for storage (S) and
transportation (T) for food storage and distribution(C), Accuracy classifica-
tion 1 (-30..+70°C), according to EN 13486 we recommend a recalibration
once per year.
2. Operation
• For configuring the data logger, please install the Software DE-LOG-Graph
on a PC.
2.1 USB-Port
• When the Software Installation has been completed please connect the PC
with data logger via USB-cable. For detailed information please read the
manual of the DE-LOG-Graph-Software.
2.2 Panel and display (Fig. 1)
Log100/110/100CRYO have a large display, two LEDs and two buttons.
A: LCD-display indicate humidity, temperature, external temperature(in case
of an external sensor), Low bat-warning, Max-Min-Avg-measurements,
status information
B: Start-Stop-button
C: Mode-button
D: LED: green/red
E: USB-port (with rubber cap)
2.3 Button-handling
• On the front panel there are two buttons. Both buttons can be de activated
by using the Software DE-LOG-Graph, to prevent unauthorized use.
15