Replacing Battery; Waste Disposal - Dostmann Log100 Mode D'emploi

DE_Log100_Cryo_Anleitung
LOG100/110/CRYO
– Data logger
Logger
is recording
2.5 LED-Indication and Buzzer
• The two LED's and the internal buzzer help you to understand all logger
information, several status modes and alarm indications.
• LED green:
The green LED flashes during the logger start and according to the measur-
ing interval if the standard settings hasn't been changed.
• LED red:
The red LED flashes when Hi- or Lo-Alarm has been achieved.
• Buzzer:
The Buzzer rings when Hi- or Lo-Alarm has been achieved(if the buzzer is
not deactivated). The Buzzer also rings when the configuration has been
transferred successful from the PC to the Logger.
• You can activate or deactivate both, LEDs and Buzzer by using the Soft-
ware DE-LOG-Graph.
2.6 USB-Port
• For readout or programming, the data logger must be connected via USB-
cable with a PC.
• View from the front: On the left side there is the USB-port. The port is pro-
tected by a small white rubber cap. To operate the USB-port please remove
the rubber cap.
18
11.10.2013 15:35 Uhr Seite 10
Battery Factory settings
(total empty)
LOG100/110/CRYO
– Data logger
• After the completed communication with the PC do not forget to plug the
rubber cap back into the port. It prevents dirt and water from entering the
data logger.
2.7 External sensor connection
• Use the USB socket to connect the external temperature sensor. Therefore
remove the rubber cap from the USB socket. Afterwards connect the exter-
nal probe by use of the socket. The probe will be registered automatically.
• Note: Using the external temperature sensor the instrument loses the splash
water protection (IP65).
2.8 Rear side of the data logger / battery case
• On the rear side of the data logger you will find the battery case and a
printed sticker.

2.9 Replacing battery

• To replace the battery please open the battery cover on the rear side. There-
fore you have to turn the battery cover 90° to the left. Remove the battery
from the instrument and replace with a new battery.
• The "BAT "symbol indicates that the battery needs to be exchanged. The
instrument allows app. 10 hours of further operation after displaying the
"BAT" symbol The battery symbol indicates according to the battery status
between 1 to 3 segments.
• If the display indicates only "PF", the battery is completely exhausted.
Please replace the battery immediately.

3.0 Waste disposal

This product has been manufactured using high-grade materials and compo-
nents which can be recycled and reused.
19