Troubleshooting And Maintenance; Cleaning The Refrigerator; Cleaning The Burner - Trigano VDL AR85W Manuel D'installation Et De L'utilisateur

7 Troubleshooting and Maintenance

If the refrigerator fails to work, check the following points before calling a service technician:
1. That the above installation and operating instructions have been followed.
2. The refrigerator is level.
3. If it is possible to start the refrigerator on any of the connected sources of energy.
4. If the refrigerator fails to work on gas, check:
a. That the gas bottle is not empty.
b. That all LP-gas valves are open.
5. If the battery ignition fails to spark, replace the battery if necessary.
If the refrigerator is not cold enough it may be because:
- The ventilation of the cooling unit is inadequate.
- The thermostat is set on the high temperature position.
- The doors are opened frequently, or the gasket is not sealed properly.
- Too much food is put at one time.
- The gas pressure is incorrect - check the pressure regulator at the gas container.
- If the refrigerator still does not work properly, call a service technician.
The sealed cooling system must not be opened, since it contains corroding chemicals under high pressure.
Maintenance
Inspect the gas hose periodically for cracks or deep chafing marks. Connections can be tested for leaks using a
soap solution.

Cleaning the refrigerator

General: Do not use harsh chemicals, abrasives, ammonia, chlorine bleach, concentrated detergents, solvents or
metal scouring pads. SOME of these chemicals may dissolve, damage and/or discolor your absorption refrigerator.
1. Remove the contents of the appliance
2. Wipe the inside and outside surfaces with a damp cloth. The addition of vinegar to the water is good for the
prevention of mold and fungus.
3. Wipe all parts thoroughly after the cleaning.
The cooling unit behind the refrigerator should be cleaned with a brush from time to time, but make sure that the
refrigerator is switched off when doing this.
The entire unit must be left for drying completely after cleaning with damp cloth

Cleaning the burner

Switch off the refrigerator, take off the protection hood and do the following:
1. Clean the openings and the burner screen with a toothbrush;
2. Clean and inspect the electrode and thermocouple. if either is
corroded, have it changed. Check that they are well attached and if
necessary tighten the screws;
3. Check that the spark is created by pressing the electric ignition
button on the control panel.
4.
Do not use thin objects to either clean or unblock the injector
Trigano-VDL AR85W / AR95 OM
Sept 2020 / V13
Do not use open flame to check for leakage in the gas tubes!
Page 17 of 114