Care And Cleaning; Changing The Light Bulbs - Dacor RF36NDFSS Manuel D'utilisation Et D'entretien

Cleaning
WARNING
Explosion Hazard
Use nonflammable cleaner.
Failure to do so can result in death, explosion, or fire.
Both the refrigerator and freezer sections defrost automatically.
However, clean both sections about once a month to avoid
buildup of odors. Wipe up spills immediately.
IMPORTANT: Because air circulates between both sections, any
odors formed in one section will transfer to the other. You must
thoroughly clean both sections to eliminate odors. To avoid odor
transfer and drying out of food, wrap or cover foods tightly.
To clean your refrigerator:
NOTE: Do not use abrasive or harsh cleaners such as window
sprays, scouring cleansers, flammable fluids, cleaning waxes,
concentrated detergents, bleaches or cleansers containing
petroleum products on plastic parts, interior and door liners or
gaskets. Do not use paper towels, scouring pads or other harsh
cleaning tools.
1. Unplug the refrigerator or disconnect power.
2. Hand wash, rinse and dry removable parts and interior
surfaces thoroughly. Use a clean sponge or soft cloth and a
mild detergent in warm water.
3. Wash stainless steel and painted metal exteriors with a clean
sponge or soft cloth and a mild detergent in warm water.
To keep stainless steel looking like new and to remove minor
scuffs or marks, it is suggested that you use the Dacor
approved stainless steel cleaner and polish, part number
A302. To order the cleaner, see www.everythingdacor.com.
IMPORTANT: This cleaner is for stainless steel parts only!
Do not allow the stainless steel cleaner and polish to come
into contact with any plastic parts such as the trim pieces,
dispenser covers or door gaskets. If unintentional contact does
occur, clean plastic parts with a sponge and mild detergent in
warm water. Dry thoroughly with a soft cloth.
4. There is no need for routine condenser cleaning in normal
home operating environments. If the environment is particu-
larly greasy or dusty, or there is significant pet traffic in the
home, the condenser should be cleaned every 2 to 3 months
to ensure maximum efficiency.
If you need to clean the condenser:
„ Remove the base grill.
„ Use a vacuum cleaner with a soft brush to clean the grille,
the open areas behind the grill and the front surface area
of the condenser.
„ Replace the base grill when finished.
5. Plug in the refrigerator or reconnect power.

Care and Cleaning

Changing the Light Bulbs

IMPORTANT: The light bulbs in both the refrigerator and freezer
compartments of your new refrigerator use LED technology. If the
lights do not illuminate when the refrigerator and/or freezer door is
opened, call for assistance or service. See Warranty and Service.
1. Unplug the refrigerator or disconnect power.
2. Refrigerator compartment only: Remove the light shield in
3. Replace the burned-out LED bulb with a bulb of the same size,
4. Replace the light shield (refrigerator compartment only).
5. Plug in the refrigerator or reconnect power.
Vacations
If You Choose to Leave the Refrigerator On While
You're Away:
1. Use up any perishables and freeze other items.
2. If your refrigerator has an automatic ice maker, and is
3. If you have an automatic ice maker, turn off the ice maker.
4. Empty the ice bin.
If You Choose to Turn Off the Refrigerator Before You
Leave:
1. Remove all food from the refrigerator.
2. Turn off the water supply to the ice maker at least one day
3. Turn off the temperature controls. See Setting the Controls.
4. Clean the refrigerator, wipe it, and dry well.
5. Tape rubber or wood blocks to the tops of both doors to prop
7
the top of the refrigerator compartment. Slide the light shield
toward the back of the compartment to release it from the light
assembly.
shape and wattage.
„ Some LED replacement bulbs are not recommended for
wet/damp environments. The refrigerator and freezer
compartments are considered to be wet/damp environ-
ments. Before installation, read and follow all instructions
on the LED packaging.
„ If an incandescent bulb is used to replace an LED bulb,
use only incandescent bulbs for household appliances with
a maximum of 40 watts.
connected to the household water supply, turn off the water
supply to the refrigerator. Property damage can occur if the
water supply is not turned off.
Raise the wire shutoff arm to the off (up) position.
ahead of time. When the last load of ice drops, raise the wire
shutoff arm to the off (up) position.
them open far enough for air to get in. This stops odor and
mold from building up.