Power Supply; Electrical Connections - DIEL MT 200 Manuel D'instruction

programming, checking of validity of the insert data during programming phase.
• Continuos storage of planned and reached values by each channel (limits and
historic highs).
• Dielectric isolation: 2.5 KV AC for 60".
• Software configuration to control the environment temperature.
• Resolution 1° C.
• Working temperature of device from -20°C to 60°C.
• Max allowed dampness in the room 90% not condensing.
• Electrical connections with fast polarised connectors.
• Possibility of manual relays switch through menu test relays to simulate and
check the reliability of contact.
• Certification for railway environment use according to EN-50121-5:2006
regulations.
• Technical manual in five languages (and more on request).
• Construction in accordance with rule EN 61000-6-2:2005 2014/30/EU.
• Input filter for power supply in accordance with rules
• Tropicalization (optional).
Perform a square hole measuring 91x91 mm in the panel board sheet.
Fasten the monitoring system trough the special hooks.
The device can be supplied with (24÷240) Volt AC/DC ±10% 50/60 Hz without
respect of polarity.
The power supply terminals are indicated with the abbreviation AL1-AL2 and are
also shown in table TAB 1 at the end of the manual.
Perform the connections on the terminal board following the scheme on TAB 1 at
the end of this manual.
FAULT relay usually results excited during normal working of device (FAULT
ASSEMBLY

POWER SUPPLY

ELECTRICAL CONNECTIONS

- 11 -
ENGLISH
.