Publicité
Les langues disponibles
Les langues disponibles
GB
Starting locomotive operation
Unwrap model: Take the loco carefully out of
the packing with the help of the foil (fig. 1).
Very important!
Before taking into service your model these
bearings of the coupling rods must be oiled as
otherwise there would be the risk of bad run-
ning qualities of damage on the locomotive (see
fig. 5).
Operating instructions: Before use is advisa-
ble to let the loco go around about 30 minutes
forwards an 30 minutes backwards without load,
to obtain an optomal circuit and best tractive po-
wer. The smallest radius this model should run is
R2 (358 mm) or rather R2 (358 mm) of the ROCO
track system.
Your locomotive will run smoothly on clean tracks
only. For this purpose we recommend using item
no. 46400, ROCO track cleaning van, or item
no. 10002, ROCO track cleaning rubber, for
removing heavy dirt.
More information about the sound decoder can be found here
10
Fittings: Operation is possible with different
couplings (fig. 2). We recommend using the ROCO
close coupling.
In the enclosed accessory bag you will find small
kits to be fitted on your locomotive. Please mount
them cautiously. Attention! Use glue only if
indicated (fig. 2).
Running in digital mode:
First remove loco body (fig. 3). Then remove the
jumper from the interface. Finally put the plug of
the chip into the interface as shown in fig. 6.
GB
Maintenance of the model
To enjoy your model for a long time, it is necesary
to service it regulary (i.e. after it has been in ope-
ration for approximately 30 hours).
1. Cleaning of wheel contacts: Wheel cont-
acts easily get dirty on tracks which are not enti-
rely clean. Use a small brush to remove dirt from
spots marked in fig. 4.
2. Lubrication: Apply tiny oil drops to spots
marked in fig. 5. Prior to lubrication dismantle the
loco body or the tender body (fig. 3). We recom-
mend using item no. 10906, ROCO oiler. For lu-
brication the gearparts (e.g. cogwheels, worm) we
would recommended our ROCO special grease
(item no. 10905).
Attention: Please do not oil these parts when
using our grease.
3. Carbon Brush Changing: First remove loco
body (fig. 3), and then the motor (fig. 7).
Assembly: During assembly please take care of
correct position of contacts (fig. 6).
3
Publicité
