modbar pour over system Manuel De Fonctionnement page 25

Optionally, you can now lock the profile
to prevent accidental reprogramming
by entering the profile edit menu and
then selecting the prevent programming
checkbox.
For a demonstration of this procedure and
other video tutorials, please visit:
www.modbar.com/support
6) Preferences screen:
Temperature units: This button sets the
system's temperature units, in: Celsius (C),
Fahrenheit (F) or Kelvin (K)
Volume units: This button sets the system's
volume units to: Milliliters (mL) or Fluid
Ounces (oz.)
Advanced: This button navigates to the
advanced preference settings page.
7) Advanced preferences screen:
Machine name: This is a descriptive name for
the module, touch the name to highlight
the field, use the encoder wheel and push-
button to rename the machine if desired.
Factory reset: This will return all of the
system settings to their original factory
values. ATTENTION! You will lose all stored
pressure profiles and other settings. A
confirmation screen is presented to confirm
the operation of Factory Reset.
Line volume: This value is used to
accommodate for water in the line between
the pour-over module and the pour-over tap.
The line volume setting may also be used
to correct discrepancies between volume of
water yielded during a pour-over pour and
volume displayed on the module.
Lighting: This button navigates to the lighting
settings screen.
Advance preferences page 2: This button
will navigate to page 2 of the advanced
preferences screen.
Save & Exit: You guessed it! This button
saves the settings changes and exits the
current screen.
Temperature mode button: This button will
toggle between Automatic and Manual
temperature modes.
Automatic temperature mode is calibrated
at the factory to deliver the best temperature
performance using a single temperature
setting.
Manual temperature mode gives you
independent control over the set points
of each temperature zone from the home
screen: Inlet boiler and outlet boiler. At
the home screen, pressing the Heat Zone
button will allow you to cycle through each
zone and set its temperature independently.
25