Table des Matières
Publicité
English
Switching on the FOM 330
Switch on the instrument by pressing the
ON/OFF button.
The device will perform a system test dur-
ing which all segments of the display are
visible in the display (A).
Thereafter the display shows two dashes
and the NextStep-display suggests to
immerse the sensor in the oil (B). The
device is ready to measure.
Measuring with FOM 330
In order to obtain optimum measuring
results, ensure the following:
Remove fried goods from the oil and
wait approximately 20 minutes
Heat up the oil at 150 °C to 180 °C
If necessary, shut down the circulating
system
Remove the sensor protection from the
sensor
Ensure that the the probe is clean and
absolutely dry
09/2016 ba80118def01_FOM330
Français
Mise en marche du FOM 330
Mettez en marche l' instrument en
appuyant sur la touche ON/OFF.
L'instrument effectue en premier un test
du système pendant lequel tous les ele-
ments de l'afficheur sont visibles (A).
Thereafter the display shows two dashes
and the NextStep-display suggests to
immerse the sensor in the oil (B). The
device is ready to measure.
Mesurer avec le FOM 330
Pour obtenir des mesures optimales, pro-
cédez comme suit:
Extrayez la friture de l'huile et attendez
approximativement 20 minutes
Chauffez l'huile à la temperature
optimale - entre 150 °C à 180 °C
Mettez à l'arrêt, le cas échéant, le
dispositif de circulation
Remove the sensor protection from the
sensor
Veillez à ce que la sonde soit propre et
bien sèche
13
Publicité
Table des Matières
