Technical Data - DOMUS LINE PYBOX Manuel D'installation

INSTALLATION MANUAL
WARNING
Safety is guaranteed if these instructions are followed
and therefore they must be kept. Installation may
require qualified personnel to be involved. Before
proceeding with installation of the device ensure that
the environmental conditions are in compliance with
and suitable for the product characteristics. Before
carrying out any operation on the device remove
mains power.

TECHNICAL DATA

- 220Vac switch: max. 500W
- SCHUKO 220Vac socket: max. 1500W
INSTALLATION (fig. 1)
- PYBOX must always be mounted under a counter or
shelf at a minimum distance of 10cm from the edge
(fig. 1)
- Secure PYBOX to the surface using the supplied
screws (A), passing them through the holes (B)
present on the rear support, then connect the front
cover (C) as shown in figure 1, ensuring that it is
properly inserted and securing it with the screws (D),
then secure the cover (E) using the fixing clips on the
body (C).
ELECTRICAL CONNECTION (fig.2)
- Disconnect the mains voltage.
EN
- The power supply cable connection to the 230V
power supply must be performed using the
connecting box (F).
- the power supply cable must not be accessible after
installing the device.
- If the cable needs to be secured, only use insulated
clips or plastic cable ties.
- If the connection box supplied is not used, use
connection devices that are certified in accordance
with the EN60998 certification standard.
- Store this connection device in an adequately-sized
box.
WARNING
- Do not use the device if the power cable and/or the
connection cables are defective. Defective cables
and/or connectors must be immediately replaced by
qualified personnel authorised by DOMUS Line.
- Do not allow the cable to pass over hot parts.
WARRANTY
- The warranty on the device is valid only if powered
by a power supply provided by DOMUS Line. The
warranty's general terms and conditions for this
device are available at www.domusline.com