Initial Use - Beurer PS 41 Mode D'emploi

16
15
14

4. Initial use

Inserting the batteries (3 x 1,5 V AA Micro)
Please remove the battery insulating strips and/or position the batteries correctly with regards to the
polarity displayed in the battery compartment. If the scale fails to operate, remove the batteries com-
pletely and reinsert them.
Set time and date
The date and time can only be changed when the batteries are taken out and replaced.
To set the current date and time, you must proceed in several stages as follows:
year – month – day – hour – minute.
The setting to be changed will fl ash each time.
• To change a setting, press the buttons
• To save the setting and move onto the next one, or to close the setting, press the SET button.
The scale will switch off automatically after this procedure.
The scale will also switch off if no buttons are pressed for more than 60 seconds.
Setting user data
The scale comes equipped with 10 locations for storing user data and space for more than 5 measure-
ment values per user. You and, for example, the members of your family can save and later access the
following personal settings in the storage locations:
Sequence
1
2
3
Press SET and select the desired memory space using the
Proceed identically to enter the gender, date of birth and height: use the
confi rm with SET.
Please note: if you change e.g. the height value at a later date, all measurement data saved
in your storage location up until that point will be deleted.
Changing the weight unit
In basic set-up, the scale displays values in kg. You can set the device to measure in kilograms ("kg"),
pounds ("lb") and stones ("st") using the switch on the back of the device.
Setting up the scale
Set up the scale on a level and solid surface. A solid surface is a prerequisite for a correct measurement.
5. Operation
Weighing only
Step briefl y and forcefully on the weighing area of your scale. The time and date appear until "
displayed. The scale is then ready to take a measurement.
All manuals and user guides at all-guides.com
8 9
13
and
User data
Memory position
Body height
Date of birth
8 Weight display/time
9 Trend
10 Average value
10
11 Interpretation
12 Height
13 Age/date of birth/date
11
14 BMI display
12
15 Average BMI
16 Gender (male/female)
.
Parameters
1 to 10
100 to 220 cm (39" to 87")
1.1.1920 to 31.12.2045
or buttons. Press SET to confi rm.
8
or buttons to select and
0. 0
kg" is