D&D Technologies LOKKLATCH Instructions D'installation page 8

FITTING INSTRUCTIONS CONTINUED...
Re-configuring the LokkBolt for Left-Hand Gates
1) Drive the Pin out of the lower end of the stainless steel rod.
2) Remove the Lower Bracket from the rod. Unlock the Lokk-Bolt to release
the Lock Housing, if necessary. Important: Hold the Lokk-Bolt HORIZONTALLY
as shown below in Diagram C, being careful to retain the Lock Housing in the
position shown.
3) Remove the rod slowly and carefully from the Lock Housing.
Very important: Steadily keep the Lock Housing in the horizontal position
shown! Reverse the rod and insert in to the other end of the Lock Housing.
Push the rod in until the upper detent groove clicks into position.
4) Test the working of the lock and then reassemble with the Lower Bracket and
the Pin (ensure at least ⁄ ", or nearly 2mm, of the Pin is left protruding
1
16
to prevent the Brackets sliding off the bolt).
Problems? If the re-configured Lokk-Bolt does not fit into the housing, or
work as expected, it may be the detent spring inside the Lock Housing has
dislodged. See Diagram D. To rectify this, the rod should be removed from the
Lock Housing and the rear cover of the housing removed by unscrewing the
three retaining screws.
Any loose parts should be re-assembled; generally this will be only the Spring
and Lever, as shown in Diagram D. When the parts are re-assembled,
the rod can be pushed back into the Lock Housing.
Replace the rear cover.
MAINTENANCE: Keep Lokk-Bolt rod clean. Lubricate the Lokk-Bolt using only graphite powder. DO NOT use oil or grease.
For a downloadable Adobe Acrobat (.PDF) version of our Limited LIFETIME WARRANTY, go to our website at
www.ddtechglobal.com
©
Copyright 2011 D&D Group P/L Sydney, Australia
this position as the rod is
removed and reversed.
DIAGRAM C
Patents, Trademarks, Registered Designs apply worldwide
18" 24"
model model
(Upper Bracket)
3.1/8"
(80mm)
Maximum
9"
(230mm)
Maximum
DIAGRAM B
Spring
DIAGRAM D
AUSTRALIA: Unit 6, 4-6 Aquatic Dr, Frenchs Forest NSW 2086
USA: 7731 Woodwind Drive, Huntington Beach, CA 92647
www.ddtechglobal.com
Lever
(cam)