Fitting Instructions - D&D Technologies LOKKLATCH Instructions D'installation

FITTING INSTRUCTIONS

gate when viewed from inside (house side).
gates, please read the instructions overleaf entitled
Tools required: Electric drill,
drill-bit (to suit masonry),
5
holes in thick steel), Phillips No. 2 screwdriver (hand &
powered types), level, pencil.
1.
should be key-locked into the upper "detent" groove*.
Locate the Lokk-Bolt on the inside of the gate (house
side), positioning it so the bottom of the bolt rests on
the ground surface (concrete, tiles, stone etc). The
Lokk-Bolt must be held or clamped so that the two
2. Mark a circle on the ground surface around the
bottom of the stainless steel rod. Drill this hole
"– " (16–19mm) to a suitable depth. (The hole will
5 3
8 4
need to be larger if a pipe is to be inserted.)
3. Locate the LokkBolt back onto the gate, with
the rod inserted into the hole to the required
depth. The position of the Lower Bracket is
important; it should be as low as possible, but
maximum measurements shown in Diagram B
overleaf. Use a pencil to mark inside the slots
of both brackets for the mounting screws, using
the brackets as the templates. Remove the
LokkBolt.
4. The LokkBolt is supplied with self-drilling
drill " (4mm) pilot holes through the
5
32
center of the marked slots. For wooden gates,
consult your local hardware expert to obtain
appropriate wood screws.
5. Insert the four Dress Caps supplied into the screw slots.
The Lokk-Bolt is now ready for use.
"– " (16–19mm)
5 3
8 4
" (4mm) drill-bit (for pilot
32
LOCK
HOUSING
(BRACKET)
Upper
Detent
Groove
(obscured)
LOWER
BRACKET
DIAGRAM A
*
The Lokk-Bolt has two detent grooves, both of which
are for either retaining or locking the rod in place. The
lower groove holds the Lokk-Bolt off the ground and the
upper groove locks the rod into place for security.
Dress
Caps
Rod
Pin
Hole depth recommended to be
minimum of 1.1/4" (30mm)