Group Selection - AUDIOropa xepton TRX-1 Mode D'emploi

How to use
2.2 Power ON / OFF
Press and hold the power button for 3 seconds to
switch the device on.
The LC-display will light up and the default volu-
me level »VOL 03« is shown.
To switch the device off after use: Press the po-
wer button again for 3 seconds. The device will
switch off.

2.3 Group selection

Switch the device on and press the MODE-button
for 3 seconds.
The symbol »GRP« in the display will blink. Select
a group number of your choice between »00« and
»39« by pressing the »+« and »-« buttons. After
the selection, wait for 3 seconds to set the selec-
ted group number.
Transmitters and receivers must be set to the
same group number if they are to communicate
with each other.
English 19