ASATech signolux Mode D'emploi page 5

you might first have to delete
the transmitter from the memory
(see section 4.)
a)
Keep the function button
pressed for some time. The
symbols begin to light up in
sequence. Let go of the fun-
ction button as soon as the
desired symbol is lit. (e. g.
doorbell symbol)
b)
Trigger the signal of the
transmitter you want to as-
sign to the lit up symbol. (e.g.
operate the doorbell button).
Wait for about 20 seconds
c)
and test the function.
4. Deleting transmitters from
receiver memory
If you wish to remove the transmit-
ters assigned to a symbol from the
receiver memory:
Keep the function button
a)
pressed for some time. The
symbols begin to light up in
sequence. Let go of the fun-
ction button as soon as the
desired symbol is lit.
b) Now press the function but-
ton and the delete button at
the same time. All symbols
will briefly light up.
Please note that this will dele-
te all transmitters assigned to
the according symbol.
Meaning of the symbols
doorbell
telephone
person call
babycry
fire alarm
alarm
Checking the last signal, dele-
ting the current signal
Shortly pressing the functiony but-
ton, the last registered signal can
be displayed again.
You can also "delete" a signal that
was just activated by pressing this
button.
(green)
(orange)
(yellow)
(white)
(red)
(red)
English 5