ASATech signolux Mode D'emploi page 4

Function button:
When you feel the »sign
ger« vibrating, you can stop the
vibration by pressing the functi-
on button on the receiver.
The indicator LEDs will stay
illuminated, but will go out au-
tomatically after a total of 40
seconds.
Furthermore, you can press
the function button to call up
the most recent signal again
(the function works for up to 3
minutes after receiving the sig-
nal).The function button is also
used to program the receiver
(see section 3 „Programming
signals").
Belt clip:
You can use the belt clip to
attach the »sign
your clothing.
On/off switch:
Use this switch to turn the pager
on and off.
Delete button:
This button serves to remove
transmitters assigned to an
indicator symbol (see section
4 „Deleting transmitters from
receiver memory").
English 4
•
lux-pa-
•
lux-pager« to
Setting up the system
1. Inserting the battery
There is a battery compartment on
the underside of the »sign
ger«. Open it by sliding the co-
ver of the battery compartment
away from the receiver using
both your thumbs.
Insert two 1.5 V AAA batteries
and close the receiver again.
2. Switching the unit on
Set the on/off switch to »on«. The
•
»sign lux-pager« is now ready
to operate. After the unit has
been switched on, the battery
status LED lights up for about a
second.
3. Programming signals and
assignment to the symbols
A transmitter (e.g. doorbell push-
button) can be assigned to each
symbol. This assignment can
be adapted by programming.
Up to 6 transmitters can be as-
signed to each symbol.Please
keep in mind that a transmitter
can only be assigned if it is not
yet known in the memory of the
•
»sign lux-pager«. If required,
•
lux-pa-