Mr. Heater MH18CH Instructions D'utilisation Et Manuel Du Propriétaire page 4

INSTALLATION OF BASE TANK SUPPORT
1. Remove the two phillip head screws from the base tank support.
3. Once the Tank Support is aligned and locked into place with
bottom of the heater screw the (2) phillip head screws into
place.
Packaged Items :
Base Tank Support
Part # 27521
4
(4) Locking Casters
Part # 27514
2. Align the Base Tank Support tabs (2) with the open slots(2) on the
bottom of the heater along with aligning the bottom heater tabs(2)
with the open slots(2) on the base tank support. Once the tabs and
slots are aligned slide down to lock into place.
TABS
SLOTS
4. Screw the (4) casters clockwise into threaded openings on the
bottom of the Tank Support and bottom of the heater.
SLOTS
TABS