Sleep Operation; Operation Mode; Health Operation - Haier AS07QS1ERA Mode D'emploi

Operation

Sleep Operation

Press button to enter additional options, when
cycle display to , will flash. And then press
enter to sleep function.

Operation Mode

1. In COOL,DRY mode
1 hours after SLEEP mode starts,temp.will become
higher than temp.setting.After another 1 hours,temp.rises
by 1 O C futher.The unit will run for further 6 hours then
stops Temp. is higher than temp.setting so that room
temperature won't be too low for your sleep.
SLEEP operation starts
Approx.6hrs
Rises 1
1 hr
O
Rises 1 C
1 hr
Temp.setting
In COOL, DRY mode
In HEAT mode
2.
1 hours after SLEEP mode starts,temp will become 2
lower than temp.setting.After another 1 hours,temp
O
decrease by 2 C futher.After more another 3 hours,temp.
O
C
rises by 1 futher.The unit will run for further 3 hours
then stops.Temp.is lower than temp. setting so that room
temperature won't be too high for your sleep.
Temp.setting
1 hr Decreases 2
1 hr
Decreases 2
3 hrs
SLEEP
operation starts
In HEAT mode
O
1 C
SLEEP operation stops
O
C
Unit stop
O
Unit stop
C
O
C
O
3 hrs
Rises 1 O C
SLEEP
operation stops
In AUTO mode
3.
The unit operaters in corresponding sleep mode
adapted to the automatically selected operation mode.
4. In FAN mode
It has no SLEEP function.
5.Set the wind speed change when sleeping
If the wind speed is high or middle before setting for the
sleep, set for lowing the wind speed after sleeping.
If it is low wind, no change.
Note
After TIMER ON setting,SLEEP is unavailable;
After SLEEP setting,then TIMER ON setting,SLEEP is
cancelled automatically.
After TIMER OFF setting,then SLEEP setting,it's available
and running as sequencing;
After SLEEP setting,then TIMER OFF setting,it's available
and running as sequencing.
POWER/QUIET Operation
(1)
POWER Operation
When you need rapid heating or cooling, you can use this function.
Press button to enter additional options, when cycle
display to ,
power function. When cancel the function, please enter
additional options again and to cancel power function.
(2)
QUIET Operation
You can use this function when silence is needed for rest or reading.
Press QUIET button, the remote controller will show
and then achieve to the quiet function. Press again this
C
QUIET button , the quiet function will be cancelled.
Note
During POWER operation, in rapid HEAT or COOL mode ,
the room will show inhomogeneous temperature distribution.
Long period QUIET operation will cause effect of not too
cool or not too warm.

HEALTH Operation

Nano-Aqua generator adopt two high voltage poles to
ionize the water molecule, produces plenty of positive and
negative ions, and release these ions to the air to kill the
bacterium, as well as to refresh the air.
will flash，and then press ,enter to
,
3