Table des Matières
Publicité
How to Use
Connecting the flexible hose
Push the end of the head (1) on the flexible
hose (2) into the attachment point on the
vacuum cleaner.
To remove the flexible hose from the vacuum
cleaner, press on the button (3) situated on the
head, then pull upwards.
Assembling the tubes
(depending on model)
• Plastic or metal tube (4).
- Fit together the two tubes by twisting slightly.
• Telescopic tube (5)
- Push spring latch (6) forward.
- Pull out tube to required length.
- Release spring latch to lock.
Using the cleaning head and Accessory
Nozzles (depending on model)
Fit the large cleaning head onto the end of
the tube.
•
The 2- position head (7) is equipped with a
pedal (8) which allows you to alter its position
according to the type of floor to be cleaned.
Hard floor position (tiles, parquet floors...).
Press on the pedal to lower the brush.
Carpet or rug position. Press on the pedal
•
to lift the brush up.
• Crevice Tool (9)
For vacuuming in those normally inaccessible
places i.e. reaching cobwebs, or down the
side of a sofa!
• Dusting brush (10)
For vacuuming picture frames, furniture
outlines, books and other uneven objects.
Upholstery Nozzle (11)
•
For vacuuming upholstery,mattresses,etc.
The thread collectors help to pick up the
threads and fluff.
How to plug in and use
Pull out the supply cord to the desired length
and plug into the socket.
Press button (13) to start the vacuum cleaner.
To stop it press the button (13) again.
Adjusting the power level
•
(depending on model)
The flexible hose handle (14) has a manual
air flow regulator (15) which allows you to
•
briefly reduce the suction level.
Electronic power control (16)
Suction capacity increases smoothly up to
MAX.
Park-System (17)
For short breaks during vacuuming, for
example to move a small piece of furniture
or a rug, use the "Park system" to support
the flexible hose and cleaning head.
Storage (18)
When you have switched off and unplugged
the appliance, press the button (12) to
automatically rewind the cord.
You can move or store your appliance in a
vertical position by sliding the hook on the
underside of the appliance.
Changing the dust bag
The dustbag needs changing when the
cleaner is set to maximum power and the
cleaner head window (19) is completely
coloured red.
Even if the dustbag does not appear to be
full at this stage. it should be changed, as
very fine dust can clog up the pores of the
dust bag.
Turn off the appliance and unplug it.
Open the cover by pressing the hook (20)
and lifting it up until it snaps into place.
Your appliance is equipped with either a
paper dust bag (21) or a fabric dust bag
(26) (depending on model.)
Take hold of the dust bag by the handle
and pull. Remove the bag and throw it
away.
To refit a new bag push the cardboard
support of a new bag into the bag mount
(22) until it will go to further.
If your appliance is fitted with a fabric dust
bag (26) follow the instructions as follows:
Pull the clip (30) out and empty the fabric
dust bag, then set the clip back and push it
until it can close the dust bag completely.
Do not wash the fabric dust bag.
Note: as the appliance is fitted with a safety
device which checks that the bag is in place
you cannot close the lid if the bag is not fitted
correctly.
- 11 -
Publicité
Table des Matières
