Important - Arzum AR 3083 Manuel D'utilisation

EN
• If the power cord is damaged,
it must be replaced by the
manufacturer, service agent, or
similar qualified personnel in order
to avoid danger.
WARNING: NEVER switch your appliance on when there is no water in
the kettle (container) or the water level is below the minimum level.

IMPORTANT:

• Unlike other samovars, it is sufficient to operate your appliance with a
single button. Your appliance automatically switches to boiling or keeping
hot depending on the temperature of the water in it.
• Your appliance will automatically switch to keeping hot position by
boiling in a short time. In keeping hot position, your appliance will work at
minimum energy level and will save 90% energy.
• Since the heating is minimum while kept in boiling condition, the existing
water can wait ready for a long time before it evaporates.
USING YOUR SAMOVAR
• Before first use, rinse your kettle with cold water several times, then
fill to MAX water level and boil the water until your appliance turns off
automatically. Pour this boiled water and rinse it with cold water. After
repeating this process 2-3 times, leave your appliance to cool down. The
water should be maximum level when doing this. Wash and rinse the
upper teapot and tea filter with warm soapy water.
• Fill the kettle (container) of your appliance with water according to the
amount of water you want by considering the max water level.
• Fill the kettle unit of your appliance with water between the tap level
and the maximum level mark, depending on the amount of tea you want
to brew. If you attempt boiling the water under the minimum level, it will
cause your appliance to shut off earlier and if you attempt boiling the
water above the maximum level, it will cause water to overflow.
• Open the teapot lid and remove the tea filter and add sufficient amount
of tea in the filter and add some cold water and then replace it on the
19
ARZUM