Arzum AR 3083 Manuel D'utilisation page 18

switch to keeping hot position and thus will save energy. When you fill
with water again, it will automatically start to boil the water again and
when the water is boiled, it will automatically switch back to keeping
hot mode. If you want to turn off your appliance completely, turn off
your appliance by pressing the on/off button.
• If your appliance is left switched on accidentally when it is empty
or when there is not enough water in it, the safe shutdown unit will
automatically cut off the energy. In such a case, wait until it completely
cools down before filling your appliance with water. You must unplug the
mains cable and plug it again to operate.
• Make sure that the water you fill in the kettle unit does not exceed the
maximum water level.
WARNING: You can only boil water in the kettle unit. NEVER use any
other liquids or solution.
• While the on / off button of your appliance is on, the teapot MUST be
put above the kettle unit. Otherwise, your appliance will delay the pass
to the energy saving position, even when the water is boiling.
• NEVER immerse the kettle (container) of the appliance in water or
other liquids, nor wash in a dishwasher, nor use in bathroom or any
other places with a high rate of moisture.
• Take care not to get your appliance's cord and electrical connectors
wet and never leave it wet. If it is wet, do not plug it to the socket and do
not operate your appliance.
• Use your appliance as recommended and fit for the purpose.
• Instructions on cleaning the
appliances normally after use and
not immersing them for cleaning
indicate that the appliance should
not be immersed in water.
• Use your appliance according
to its intended use as
recommended.
18
ARZUM