Cleaning And Maintenance - Sauber PAC-125773 Mode D'emploi

Continuous Drainage
Under normal use, the unit can evaporate the condensate water automatically by the splash motor. If the
water splash motor is damaged, continuous drainage (drain the water from the bottom outlet) can be used
manually. Under this condition, the water full indicator will light up. Please remove the rubber boot and then
the rubber stopper from the drainage outlet and connect a drain hose to the outlet, then all the water in the
water tank will be drained out. The unit can also work well. But in order not to decrease the efficiency of the
performance, please contact authorized service technician to repair the splash motor as soon as possible.
When you plan to leave this unit unused for a long time, please also remove the rubber stopper from the
drainage outlet at the bottom of unit, and drain out all the water.

CLEANING AND MAINTENANCE


Before cleaning, be sure to disconnect the appliance from any electric supply outlet.

Do not use gasoline or other chemicals to clean the appliance.

Do not wash the appliance directly.

If the appliance is damaged, please contact the dealer or repair shop.
Air Filter
If the air filter becomes clogged with dust/dirt, the air filter should be cleaned once every two weeks.
- Pull out the air filter from the air inlet grille by the pull tab.
- Clean the air filter with neutral detergent in lukewarm water (40℃) and dry it up in the shade.
- Insert the air filter back into the air inlet grille; replace the components as they were.
Clean the Surface
First clean the surface with a neutral detergent and wet cloth, and then wipe it with a dry cloth.
TROUBLESHOOTING
Troubles Possible Causes
Appliance does Water full indicator light blinks, and water
tank is full.
not start when
pressing the
Room temperature is lower than the
power button setting temperature.
The doors or windows are not closed.
There are heat sources inside the room.
Not cool enough
The hot air exhaust hose is not connected
or blocked.
Temperature setting is too high.
Air inlet is blocked.
The ground is not level or not flat enough.
Noisy
The sound comes from the flowing of the
refrigerant inside the appliance.
E0 Code Room temperature sensor failed.
E1 Code Condenser temperature sensor failed.
Solutions
Remove the rubber stopper to dump
the water out from the drainage outlet.
Reset the temperature.
Make sure all the windows and doors
are closed.
Remove the heat sources if possible.
Connect or clean the hot air exhaust
hose.
Reset the temperature.
Clean the air inlet.
Place the appliance on a flat, level
surface if possible.
It is normal.
Replace the room temperature sensor.
Contact authorized service technician
for repair.
Replace condenser temperature sensor.
Contact authorized service technician
for repair.
- 29 -