Cleaning And Maintenance; Technical Data - Sauber PAC-125336 Mode D'emploi

CLEANING AND MAINTENANCE


Before cleaning, be sure to disconnect the appliance from any electric supply outlet.

Do not use gasoline or other chemicals to clean the appliance.

Do not wash the appliance directly.

If the appliance is damaged, please contact the dealer or repair shop.
Air Filters
If the air filters become clogged with dust/dirt,
they should be cleaned once every month.
- Pull out the air filters by their respective pull
tab.
- Clean the air filters with neutral detergent in
lukewarm water (< 40℃) and dry them up in
the shade.
- Reinstall the air filters.
Clean the Surface
First clean the surface with a neutral detergent and wet cloth, and then wipe it with a dry cloth.
TROUBLESHOOTING
Troubles Possible Causes
The doors or windows are not closed.
There are heat sources inside the room.
The hot air exhaust hose is not connected
Not cool enough
or blocked.
Temperature setting is too high.
Air inlet or outlet is blocked.
The ground is not level or not flat enough.
Noisy
The sound comes from the flowing of the
refrigerant inside the appliance.
Code "E2" on the
Room temperature sensor failed.
digital display
Code "E3" on the
Evaporator temperature sensor failed.
digital display
Code "E4" on the
Water-full warning
digital display

TECHNICAL DATA

Below data for your operating reference
Model
Rated voltage
Rated frequency
Solutions
Make sure all the windows and doors
are closed.
Remove the heat sources if possible.
Connect or clean the hot air exhaust
hose.
Reset the temperature.
Clean the air inlet or outlet.
Place the appliance on a flat, level
surface if possible.
It is normal.
Replace the room temperature sensor.
Contact authorized service technician
for repair.
Replace evaporator temperature sensor.
Contact authorized service technician
for repair.
Drain out the water.
PAC-125336
220-240V
50Hz
- 29 -