Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
temperature reaches the set temperature. The compressor will be turned on automatically when the room
temperature increases above the set temperature. The fan inside is always working throughout this
process. When the compressor is working, the unit will vibrate slightly. This is normal and harmless.
3. Wind speed button
Press the button "SPEED" to switch the wind speed between low and high. The corresponding indicator
light "LOW"/"HIGH" will illuminate.
4. Mode button
Press the button "MODE" to choose your desired working mode among cooling, dehumidification and fan.
-
Under cooling mode, the corresponding indicator light "COOL" will illuminate. Press the button
"TEMP+"/"TEMP-" to set your desired room temperature. Press the button "SPEED" to set your desired
wind speed.
-
Under dehumidification mode, the corresponding indicator light "DEHUM" will illuminate. The
appliance will automatically set the working temperature (2℃ below the current room temperature)
and set the wind speed at low. Temperature and wind speed cannot be adjusted manually.
-
Under fan mode, the corresponding indicator light "FAN" will illuminate. Press the button "SPEED" to
switch the wind speed between low and high. Please note: Under this mode, no temperature function
is equipped. The digital display shows a value of "25" and that is meaningless.
5. Timer on/off button
Timer ON setting:
When the appliance is OFF, press the button "TIMER", the corresponding indicator light "TIMER" will
-
illuminate.
Press the button "TEMP+"/"TEMP-" to select a desired ON time from 1-24 hours. The "Preset ON Time"
-
will flash on the digital display. Press the button "TIMER" again (when still flashing) and the setting will
be in effect.
The appliance will automatically turn on once the "Preset ON Time" has past.
-
Timer OFF setting
When the appliance is ON, press the button "TIMER", the corresponding indicator light "TIMER" will
-
illuminate.
Press the button "TEMP+"/"TEMP-" to select a desired OFF time from 1-24 hours. The "Preset OFF
-
Time" will flash on the digital display. Press the button "TIMER" again (when still flashing) and the
setting will be in effect.
The appliance will automatically turn off once the "Preset OFF Time" has past.
-
Note: The digital display will show the countdown time by hour after the timer is set. Press the button "TIMER"
again, the timer function will be canceled.
NOTE: The appliance will keep working with the previous set mode once turned on again without being
unplugged. If the appliance has been disconnected before, it will begin to work under cooling mode at low
wind speed once turned on again.
CAUTIONS for cooling and dehumidification operations:
When using functions on cooling and dehumidification, keep an interval of at least 3 minutes between
-
each power on or off.
Power supply shall meet the requirements.
-
The socket is suitable for AC use.
-
Do not share one socket with other appliances.
-
Power supply is AC220-240V, 50Hz.
-
Water full alarm function of the internal tank
The inner water tank in the air-conditioner has one water level safety switch, it controls the water level. When
water level reaches an anticipated height, the water full indicator lights up. When the water is full, please
remove the rubber stopper from the drainage outlet at the bottom of unit, and drain out all the water.
- 28 -
Publicité
Table des Matières
