Rainfresh RL3 Instructions

WATER FILTER REMOVAL
AND INSTALLATION INSTRUCTIONS
MODEL RL3
INSTRUCTIONS
1. Push button to open filter cover
2. Pull cartridge down. Pull out the filter.
NOTE: If the filter is hard to remove, turn off water
supply and relieve pressure at refrigerator door
water dispenser before installing new filter
3. Holding new filter, remove the packaging
and end-cap
4. Push the new filter into the manifold hole until
it stops
5. Push the cover back up until it clicks into place
6. Run water from the dispenser for 5 minutes at
0.5 GPM (about 2½ gallons) to
clear the system and prevent sputtering.
7. Reset the "replace filter" light, if needed, by
holding the reset button for three seconds.
8. Check the filter for any leaks. Inspect the mount
area and filter bottom for any sign of moisture.
Your new filter is ready for use
1.
2.
3.
4.
Protect filter cartridge from freezing.
Do not use with water that is microbiologically unsafe or of
unknown quality without adequate disinfection before or after
the system.
Cartridge Life : 200 US Gal (757 L) or 6 months
Tested and cer fied by The Water Quality Associa on
to NSF/ANSI 53*, NSF/ANSI 42* and to CSA B483.1
* See performance data sheet for details
Envirogard Products Limited
446 Major Mackenzie Dr E, Richmond Hill, ON, L4C1J2, CANADA
Help Line : 1800 667 8072 Toronto & Area : (905) 884 9388
www.rainfresh.ca
©
Copyright . Envirogard Products Limited . 2016 . All rights reserved
09/2016
5.
6.
7.
8.