Listening To The Radio - Bigben TD103 Mode D'emploi

Battery power:
Be sure that the batteries are inserted correctly to avoid damage to the appliance. Always remove the
batteries when appliance will not be used for a long period of time, as this will cause leakage to the
batteries and subsequently damage to your set.
Use batteries of the same type. Never use different types of batteries together.
Do not throw the battery into the fire, or exposed to sunshine or the like.
If the liquid contained in the batteries comes in contact with eyes or skin, wash the area immediately
and carefully with clear water and consult a doctor.
Connection
1. Connect the Power Cord (27) to the AC outlet.
2. Turn the Power On/Off knob (16) clockwise until the Power LED indicator (11) lights up. This
means the power supply is normal. Now your system is ready to play music.

Listening to the radio

Manual tuning
1. Turn on the Power (16) and switch the Function knob (7) to the "Tuner" position.
2. Tune to the required station by turning the Tuning knob (10).
3. Adjust the Volume knob (16) to the desired volume level.
FM & FM-stereo reception
• Set the FM mode switch (17) to the "FM" position, programs are received in Mono mode. In particular
when stereo signal are weak. It is preferable to receive the program in Mono.
• Set the FM mode switch (17) to the "FM-ST" position to receive stereo programs. The FM-Stereo
LED indicator (19) will light up to show an FM Stereo program is being received.
Hints for best reception:
• FM: The receiver has a built-in FM Wire antenna (26) hanging from the rear cabinet. This wire
should be totally unraveled and extended for best reception.
Listening to the record player
NOTE:
• Remove the stylus protector.
• Be sure that the tone arm is detached from the tone arm rest before
operating and re-secured again afterwards.
1. Switch to the "Phono" function on the Function knob (7)
2. Set the speed selector (22) to the right position depending on the record
to be played.
3. Place the record on the platter (use the Spindle adaptor (21) if required).
4. Lift the tone arm from the rest and slowly move it to the side of the record.
The platter will start to rotate.
5. Place the tone arm in the desired position on the record.
6. Adjust the volume (16) to the desired level.
7. At the end of the record, the platter will automatically stop rotating. Lift the
tone arm from the record and return to the rest.
8. To stop manually, lift the tone arm from the record and return it to the rest.
- EN 4 -