Carat MIXER 50 SUPER Mode D'emploi page 19

• If necessary, allow the glue to rest for 5-15
minutes and then mix it again for few minutes.
As indicated in the foregoing paragraphs, the
machine may be moved directly to the position
where the glue is to be used.
Cement
• The mixing machine is suitable for preparing
mortar from plaster containing lime, cement and
fine sized aggregates. It is not suitable for
mixing concrete or mortar containing mediurn-
large sized gravel or aggregates.
• For the preparation of mortar for plaster,
proceed as described in the foregoing
paragraph: Glue for floor and wall tiles.
• As the mortar is a highly hygroscopic
preparation, in order to prevent excessive
hardening of the compound, a great deal of
attention must be paid to the addition of lime,
cement or aggregates when nearing the end of
the mixing process.
Epoxy resins
• For mixing epoxy resin, check the viscosity and
the density of the products to be prepared, so
that the mixers motor is not overloaded.
• Pour into the drum the quantity of resin,
hardener and any powders indicated by the
products' supplier.
• Mix carefully to prevent bubbles or lumps
forming in the mixture.
Paints
• Pour the paint to be mixed into the mixer drum
and add the necessary amount of water
required for the solution.
CAUTION !
! The use of chemical products or solvents
may affect the properties of the basket, made
of high density polyethyiene PET.
! Check the compatibility of the products to be
mixed with the properties of the machine
before use.
7. Maintenance
The machine's reduction unit is lubricated with
semi-fluid type synthetic grease suited for the
lubrication of enclosed gears in casings.
When changing the grease, use only products with
the characteristics listed below:
NLGI Degree:
Dropping point: °C
Thickening agent
CAUTION !
To change the grease, contact your local dealer.
8. Disposal
• In the event of the basket becoming worn or
damaged, it must be disposed of in accordance
with the methods laid down by current
legislation.
• In the event of scrapping the complete machine,
it must be disposed of in accordance with the
methods laid down by current legislation.
Electric Motor
Aluminium
Steel
Copper
Poiyamide
Machine's Framework
Steel
Poiyamide
Polyethylene
The European Directive 2002/96/CE
arranges that in the event of scrapping of
electrical equipment, they must not be
disposed of city solid refusals but collected
separately, in order to optimize the level of recovery
and recycling of the materials and above all in order
to prevent damages to health and environment.
To comply with European Directive 2002/96/CE, all
electrical equipments must be marked with crossed
basket symbol.
The packing of the machine will be disposed of in
accordance with the methods laid down by current
legislation.
For further information concerning disposal of
electrical equipment, please refer to public
administration service.
19
0
115
SODIUM SOAPS
Basket
GB
AL
AC
CU
PA
AC
PA
PET