Fit The Accessories - JT2D SUPNNPACK90BL Manuel D'utilisation

B . FIT THE ACCESSORIES
CENTRAL FIN
1) Slide the fin in the rail's case of the board
The fin can be set up before or after inflating the board.
Put the fin's back into the rail of the board's case. Slide it backwards until you
1.
reach the rail's bottom.
2. Slide the pin into the slot located between the fin and the case. The fin is
installed.
CONNECTING THE LEASH
1. Put the leash's string through the ring at
the rear of your board
3. Be sure the leash is tied firmly
2) Lock the fin by inserting the pin into the
provided slot inside the rail
2. Close the two Velcro above the string.
4. Attach the Velcro under your knee
2
25