Bosch 1364 Consignes De Fonctionnement/Sécurité page 8

BM 1609929C59 12/02 12/10/02
To prevent serious personal
WARNING
!
injury, always disconnect the
plug from power source before changing
wheels, or making any adjustments.
INSTALLING ABRASIVE WHEELS
Always use the arbor nut that has same
thread size as spindle.
1. Install inner flange onto spindle, with
recess in back side of flange engaging
matching area on spindle.
2. Install abrasive wheel onto spindle.
Always use wheel guard,
WARNING
!
foot plate and auxiliary
handle with this abrasive cut off machine.
PADDLE SWITCH
WITH "LOCK-OFF" FEATURE
The Paddle Switch enables the operator to
control switch functions of "Lock-OFF", and
"ON/OFF".
TO UNLOCK SWITCH AND TURN TOOL
"ON": Push the paddle lever FORWARD
(toward the spindle) then squeeze the paddle
lever.
TO SWITCH TOOL "OFF": Release pressure
on the paddle lever. The switch is spring
loaded and will return to "OFF" position
automatically.
SIDE HANDLE
The side handle, used to guide and balance
the tool can be bolted to either side of the
spindle housing depending on personal
preference and comfort. Always use the side
handle for maximum control and ease of
operation.
ADJUSTING DEPTH OF CUT
Loosen wing nuts, raise or lower foot plate
to desired depth, and securely tighten wing
nuts by hand.
To prevent recoil and
WARNING
!
damage to the tool, always
adjust the foot plate to a depth of so the
inner or outer flanges never contacts the
workpiece surface.
9:44 AM Page 8
Assembly
3. Install outer flange with flat side out.
4. Thread arbor nut provided onto spindle
finger tight, depress spindle lock and tighten
wheel with the wrench provided.
WARNING
!
overtightened.
CAUTION
!
Operating Instructions
WING
-8-
Do not overtighten. Cracks
in the wheel can occur if
Do not depress spindle lock
while the tool is running.
1
0
PADDLE
SWITCH
WING
FOOT
NUT
NUT PLATE