D-Link DAP-1820 Guide D'installation Rapide page 5

When the Status LED turns solid green, this indicates that the DAP-1820 is
4
securely connected to your wireless router or access point. You can now unplug
and move the DAP-1820 to a location between your wireless router and the
area that you need wireless coverage.
If after moving your DAP-1820, the signal strength
indicators are showing one single amber bar or if the
DAP-1820 is not connecting (Status LED is no longer
green), move the DAP-1820 to a wall outlet closer to
your wireless router or access point.
Note: WPS may not be enabled on all Routers or Modems. If
the Status LED on your Range Extender does not turn solid
green after running WPS setup, try again. If it still does not
turn solid green, see Configure the DAP-1820 Using D-Link
Wi-Fi Setup, on page 6.
Your setup is complete! To connect your wireless devices to your DAP-1820, see
Connect Your Wireless Devices, on page 7
DAP-1820 Install Guide 5