D-Link DAP-1820 Guide D'installation Rapide page 4

There are two easy ways to set up your DAP-1820.
It is recommened that you use Method One if your router has a WPS
button. If your router does not support WPS or you are not sure, see
Method Two, Configure the DAP-1820 Using D-Link Wi-Fi Setup, on page 6.
Method One: Connect to Your
1 Find an available outlet near your wireless router.
Plug in the DAP-1820 and wait until the Status
LED is blinking amber.
Press the WPS (Wi-Fi Protected Setup) button
2
on your wireless router.
Within one minute, press the WPS button on
3
the DAP-1820. The Status LED will start to blink.
4
Router Using WPS
DAP-1320
WPS
DAP-1820 Install Guide