Inateck BR1003 Manuel D'instructions page 4

2. Automatically Pairing with Previously
Paired Devices
B R 1 0 0 3 w i l l e n t e r p a i r i n g m o d e
automatically when powered on for
the first time. BR1003 can remember
p r e v i o u s l y p a i r e d d e v i c e s a n d
will attempt to pair with devices
automatically, without going into
pairing mode.
3. Quick Pairing
Quickly double-click the Multifunction
Button to enter pairing mode after the
BR1003 is powered on.
4. TX/RX Mode Switch
RX/TX mode can only be successfully
switched after the adapter is turned off
for 5 seconds.
Note: Turn off the BR1003 and restart
it after 5 seconds if the mode switch is
not functioning properly.
5. Clear Pairing History
Please follow the guides below to clear
the pairing history if pairing failures are
encountered:
1) Turn off the BR1003, switch TX (RX) mode
to RX (TX) mode after 5 seconds, and then
restart the BR1003.
2) Turn off the BR1003, switch RX (TX) mode to
TX (RX) mode after 5 seconds.
After that, the pairing history of TX (RX)
mode will be cleared.
3