Bercomac 700279-3 Mode D'emploi page 9

ASSEMBLY
Install the push bar (item 1) by inserting it in the sleeve
(item 2) welded on the pivot support (item 3).
Install the other end in the fork (item 4) with a pin (item
5) the head toward the outside and with a 2.5 mm hair
pin (item 6).
Install push bar
Install the handle support (item 1) on the left rear
support (item 2) with two 5/16 x 3/4'' hex bolts (item 3)
and secure with flange nuts (item 4).
Install the plastic grommet (item 5) on the handle
support (item 1).
Install handle support
INSTALLATION OF THE SUPPORTS FOR THE
BERCO CAB:(all models) (if required).
This subframe includes the front supports to be able to
install the Berco cab.
The left support for the cab (item 6) is welded to the
handle support (item 1).
Install the right support for the cab (item 7) on the right
rear support (item 8) with two 5/16 x 3/4'' hex bolts (item
9) and two flange nuts (item 10).
Use the 5/16 x 1/2'' square head socket set screws
(item 11) to secure the cab's front rod supports included
with cab.
Install the right support for cab
7