Bercomac 700279-3 Mode D'emploi page 12

STEP 3
SNOWBLOWER INSTALLATION:
Refer to Snowblower owner's manual, parts breakdown
section for parts identification.
9
WARNING
FOR YOUR SECURITY:
Read the Snowblower's owner's manual for
safety precautions and rules.
Follow the assembly and operation instructions.
Attach the snowblower to the subframe as shown.
Make sure the snowblower is pushed in until locked
into place by the springs (item 3).
Turn the handle (item 1) towards the back and install
the chain (item 2) on the hook (item 4).
Turn the handle towards the front to apply tension on
the spring.
Remove belt guard.
Install the belt around the pulleys as shown.
Install the belt on the drive mechanism pulley (item 5)
under the tractor.
Apply tension on the belt by pulling up the belt tension
arm.
Reinstall the belt guard.
NOTE: See belt replacement instructions in the
maintenance section of the snowblower owner's
manual.
9
CAUTION
The belt tension arm is spring loaded & needs to be
held firmly while displacing to prevent injury
9
CAUTION
Never use the snowblower without the belt guard.
ASSEMBLY
9
TO PREVENT INJURIES:
Stop the motor.
9
Apply parking brake.
Remove the ignition key.
Disconnect the wire from the spark plug(s) and
keep away from spark plug(s) to prevent accidental
starting.
9
Item 1: Snowblower pulley
Item 2: Tractor engine pulley
Item 3: V pulley L.H.
Item 4: Flat pulley R.H.
.
Item 5: Drive mechanism pulley
9
10
WARNING
Install snowblower
Install V-belt and belt guard
9