Technoline WT 488 Guide D'instructions page 6

Components of the alarm clock
Top view
1 – Down button
2 – VOL button
3 – Radio / Sleep button
4 – Snooze / Dimmer button
Front view
8 – Alarm 1 icon
9 – Alarm 2 icon
10 – Time
Back view
13 – Battery
14 – Power connection
Use the product only for its intended purpose!
Precautions

This main unit is intended to be used only indoors.

Do not subject the unit to excessive force or shock.

Do not expose the unit to extreme temperatures, direct sunlight, dust or humidity.

Do not immerse in water.

Avoid contact with any corrosive materials.

Do not dispose this unit in a fire as it may explode.

Do not open the inner back case or tamper with any components of this unit.
Batteries safety warnings

Use only lithium batteries, not rechargeable batteries.

Install batteries correctly by matching the polarities (+/-).

Always replace a complete set of batteries.

Never mix used and new batteries.

Remove exhausted batteries immediately.

Remove batteries when not in use.

Do not recharge and do not dispose of batteries in fire as the batteries may explode.

Ensure batteries are stored away from metal objects as contact may cause a short circuit.

Avoid exposing batteries to extreme temperature or humidity or direct sunlight.

Keep all batteries out of reach from children. They are a choking hazard.
Power up the clock radio
Insert the AC/DC adaptor to any 230V AC household outlet. Then insert the DC jack to the back case of the unit.
The clock radio will be powered on at low brightness. Press
needed and it is ready to work.
Backup battery installation (optional)
The clock radio requires one CR2032 lithium battery (not included) to provide backup power to the clock in the
event of a temporary power interruption.
1. Place the unit face down on a flat and soft surface.
2. Loosen the screw on the battery compartment cover.
3. Slide and remove the battery cover at the bottom of the unit.
4. Insert one CR2032 lithium battery into the battery compartment with the "+" side facing up as indicated.
5. Replace the battery cover and tighten the screw again.
If AC power is interrupted, the LED display will go off and both the radio and the alarm will not function. The
backup battery will keep the time and all settings of your unit. Make sure a fresh CR2032 lithium battery is used.
A fresh CR2032 battery could backup your clock continuously for around 1 week.
5 – SET button
6 – Alarm 1.2 button
7 – Up button
11 – Sleep icon
12 – PM icon
15 – AC wall socket
16 – AC / DC adaptor
once to adjust to high LED brightness if
GB 2